The obsolete gasket that seals the valve guide to the compression tube can normally be reused. If your gun is very old and has been treated with any petroleum distillates and/or solvents that damage rubber seals, the removal of the old parts can be challenging. This kit includes parts that are still available from Crosman and may require slight modification. ![]() The included valve tool (pictured on this page) is needed to remove the parts from the soldered valve body (directions included with kit). ![]() If your gun has a rounded square hole with a valve stem sticking up through it, then the kit shown on this page will fit your gun.If the compression tube appears to be brass & is one piece with a pin protruding from it, you'll need the other kit (CR/RepairKitC9) instead of this one.Remove the guide pin, spring & hammer to reveal the compression tube.Remove the pins or screws that hold the retention cap at the rear of the receiver. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |